background image

modules (sensors and sirens) match exactly.

5. Zone Code Settings

The sensor is supplied with a pre-assigned Zone setting. The sensor can be assigned  to a different zone as 

follows:

• Unscrew and remove the battery compartment cover on the rear of the sensor.

• In the area marked “Zone Code” there are eight pairs of metal contacts with a number next to each.

• The number corresponding to the pair of contacts which is plugged with a jumper is the current zone.

• To re-assign to a different zone, simply unplug the jumper from its current zone and plug it across the 

contacts corresponding to the new zone number selected.

6. Maintenance

The product may be cleaned with a soft damp cloth and then wiped dry. Do not use abrasive, solvent based 

or aerosol cleaners as this may damage and/or discolour the product. Do not allow water to enter or attempt 

to clean inside the unit.

7. Batteries

Do not allow the batteries to corrode or leak as this may cause permanent damage to the product. Take care 

to insert the batteries with the correct polarity as shown inside the battery compartments. Do not mix new and 

old batteries or different types of batteries. Do not use rechargeable batteries.

At the end of their useful life the batteries should be disposed of via a suitable recycling centre. Do not 

dispose of with your normal household waste. DO NOT BURN.

8. Alarm System Limitations

Even the most advanced alarm systems cannot guarantee 100% protection against burglary or 

environmental problems. All alarm systems are subject to possible compromise or failure-to-warn for a 

variety of reasons.

Please note that you may encounter problems with your system if:

• The sensors are not placed within hearing range of persons sleeping or remote parts of the premises.

• The sensors are placed behind doors or other obstacles.

• Intruders gain access through unprotected points of entry (where sensors are not located).

Jumpers for 
house security 
code

- Smart Panel
- Each sensor
  Default house code: 
  1: ON, 2: ON, 3: ON, 4: ON
 *Jumper: ON = Plugged, OFF = Pull Out

Dip-Switches
for house 
security code

- Key Fob Remote
Default house code: 1: ON, 2: ON, 3: ON,
4: ON

Jumper for 

Zone Code

Default zone code:Zone 8

. 3 .

Reviews: