Red Sea ReefMat 1200, User Manual

Page: 23 / 92

Red Sea ReefMat
®
23
ENG
• Rotate the dispensing roll by hand to take up the released fleece-mat.
This may dislodge whatever is causing the blockage without having to
remove the mat retainer.
• Press on the wind button until the fleece-mat advances about 5cm or
2”. If this does not resolve the blockage then do the following:
• Open the front flap and move the dispensing roll from the head to
the flap.
• Raise the mat-retainer and remove it from the fleece-mat.
• Wash the mat-retainer and ensure that the guide rollers can rotate
freely.
• Return the mat-retainer to the fleece-mat and lock it back into
position inside the filter chamber.
• Return the dispensing roll to the head, close the flap and press the
wind button until the dispensing roll begins to rotate.
If the take up shaft is still rotating without advancing the fleece-mat or
the fleece-mat has torn, remove the used fleece-mat from the take-up
shaft (cut the fleece-mat if required) and reinsert the fleece. Note:
The usage counters will continue as normal as they are not affected by
removing material from the take-up roll.
Once the jam has been resolved, restart the unit either from ReefBeat by
pressing the “Resume” button or directly from the drive-unit by pressing
on the wind/unwind buttons at the same time for 2 seconds.
Note: If the Jammed-Mat notification occurs within the first day of
onboarding ReefMat to the ReefBeat, check that the Left/Right setting
for the drive unit is correct. The wrong drive unit position setting will
cause the “Jammed-Mat” state as soon as the first mat advance occurs.
Homepage>settings page>more settings>Drive-unit position
End of Roll
When a roll ends, the drive-unit will stop trying to advance the fleece-
mat and wait for you to install a new roll. The status indicator LED on the
drive unit will blink. The ReefBeat App will receive a notification and the
status in the homepage will be shown as “End of Roll”.
Once the new roll has been installed, open the ReefBeat App and select
the “New roll installation” from the settings page. If you are installing a
partially used roll instead of a full new roll, see the instructions below.
No Level sensor
If the level sensor is not connected to the drive-unit, the ReefMat
cannot function. The status indicator LED on the drive-unit will blink. The
ReefBeat App will receive a notification and the status in the homepage
will be shown as “No sensor”.
Once the sensor has been connected the drive-unit will return
automatically to Auto-Advance.
High-Water
If the water level in the sump rises to the operating water level inside
the ReefMat filter chamber (such as when the main return pump has
been switched off) the drive-unit will stop trying to advance the fleece-
mat until the water level in the sump drops (such as when the main
return pump has been switched on again). While the High-Water state is
detected the status indicator LED will blink and the status in the ReefBeat
App will be shown as “High-Water”.