Red Sea ReefMat 1200, User Manual

Page: 13 / 92

Red Sea ReefMat
®
13
ENG
Remove the mat-retainer from the bottom
of the filter chamber by rotating the center
tube 180 degrees (water outlet slits facing
upwards) and lift.
Place the filter chamber into
the chosen location inside
the sump and connect the
inlet hose to the inlet port on
either the left or right side of
the filter chamber.
Make sure that the front and
rear filter grids are in position
inside the chamber and click
the ReefMat Head unit into
place.
Connect the DC power-supply to the 2-pin power inlet port at the rear of the
drive-unit.
Connect the water level sensor to the 4-pin inlet port at the rear of the
drive-unit.
Mount the drive-unit on
either the left or right
side of the ReefMat
Head and secure it in
position with the clip
provided. Make sure
that you have enough
room by the side of the
drive-unit to operate the
Wi-Fi setting and Wind/
Unwind buttons.