background image

7

BATTERY & TIME KEEPING

A battery is used to keep time when the unit is without power. Typical 

accuracy of the G310 time keeping is less than one minute per month drift. The 

battery of a G310 unit does not affect the unit’s memory, all configurations and 

data is stored in non-volatile memory.

To change the battery of a G310, remove power, cabling, and then the rear 

cover of the unit. To remove the cover, remove the five screws designated by the 

arrows on the rear of the unit. Then, by lifting the top side, hinge the cover, thus 

providing clearance for the connectors on the bottom side of the PCB as shown 

in the illustration below. Install in the reverse manner.

Remove the old battery* from the holder and replace with the new battery. 

Replace the rear cover, cables, and re-apply power. Using Crimson or the unit’s 

keypad, enter the correct time and date.

* Please note that the old battery must be disposed of in a manner that 

complies with your local waste regulations. Also, the battery must not be 

disposed of in fire, or in a manner whereby it may be damaged and its contents 

come into contact with human skin.

The battery used by the G310 is a lithium type CR2025.

BATTERY

INVERTER

TOP

BOTTOM

G310C2

WARNING - EXPLOSION HAZARD - THE AREA MUST BE KNOWN 

TO BE NON-HAZARDOUS BEFORE SERVICING/ REPLACING 

THE UNIT AND BEFORE INSTALLING OR REMOVING I/O WIRING 

AND BATTERY.

WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT

EQUIPMENT UNLESS POWER HAS BEEN DISCONNECTED

AND THE AREA IS KNOWN TO BE NON-HAZARDOUS.

CAUTION: RISK OF ELECTRIC SHOCK

The inverter board, attached to the mounting plate, supplies the 

high voltage to operate the backlight. Touching the inverter board 

may result in injury to personnel.

CAUTION

: The circuit board contains static sensitive 

components. Before handling the operator interface without the 

rear cover attached, discharge static charges from your body by 

touching a grounded bare metal object. Ideally, handle the 

operator interface at a static controlled clean workstation. Also, 

do not touch the surface areas of the circuit board. Dirt, oil, or 

other contaminants may adversely affect circuit operation.

WARNING - EXPLOSION HAZARD -

  

BATTERIES MUST ONLY BE CHANGED IN AN 

AREA KNOWN TO BE NON-HAZARDOUS.

BATTERY

G310R2 and G310S2

Summary of Contents for G310C2









Reviews: