7. Projector DMX start address selection
All fixtures should be given a DMX starting address when using a DMX signal, so that the
correct fixture responds to the correct control signals. This digital starting address is the channel
number from which the fixture starts to “listen” to the digital control information sent out from
the DMX controller. The allocation of this starting address is achieved by setting the correct
number on the display located on the base of the device.
You can set the same starting address for all fixtures or a group of fixtures, or make different
address for each fixture individually.
If you set the same address, all the units will start to “listen” to the same control signal from the
same channel number. In other words, changing the settings of one channel will affect all the
fixtures simultaneously.
If you set a differ
ent address, each unit will start to “listen” to the channel number you have set,
based on the quantity of control channels of the unit. That means changing the settings of one
channel will affect only the selected fixture.
In the case of the led move head, which is a 17 channel fixture, you should set the starting
address of the first unit to 1, the second unit to 18(17 + 1), the third unit to 35 (17+ 18), and so
on.
8. Control Board
The Control Board offers several features: you can simply set the starting address , run the
pre-programmed program or make a reset.
The main menu is accessed by pressing the
-button until the display starts flashing.
Browse through the menu by pressing the
-button ,
-button ,
-button or
-button. Press the Enter-button in order to select the desired menu. You can change the
selection by pressing the the
-button ,
-button ,
-button or
-button.
Confirm every selection by pressing the
-button. You can leave every mode by pressing the
-button. The functions provided are described in the following sections. it will exit from
flash 10 seconds after the last keypress. Press this key under edit mode, . The functions provided
are described in the following sections.
To access the display menu via the internal battery, press the DC switch button for 2seconds;
To shut off the display immediately, choose the commend " Reset All" menu and press
"Enter" button, otherwise, the display will automatically switch off about 1 minute from
last button press.