29
U
T
M
J
29
13 - MAINTENANCE AND CLEANING
Technical Dept. - All rights reserved - Reproduction prohibited
CLEAN THE HEAT EXCHANGER AND THE COMPARTMENT BENEATH THE BRAZIER EVERY 2/3 DAYS
Cleaning the heat exchanger and the compartment beneath the brazier is a simple operation but very important if the boiler is to maintain
optimal performance.
We therefore recommend cleaning the internal heat exchanger every 2-3 days, performing these simple operations in sequence:
•
Activate the “CLEANING” function
- with the boiler off press - menu, select “Settings”, with the arrows <> select “Cleaning”,
confirm with the “Menu” key, activate the cleaning “ON” with the + - keys. This procedure starts the smoke extractor on the maximum
setting to expel the soot that becomes dislodged when the heat exchanger is cleaned.
•
Clean the pipe unit
– Using handle “
U
”, shake the rods located under the front boiler cover vigorously 5-6 times. This should
remove the soot that has deposited on the smoke ducts of the heat exchanger during normal use of the boiler (
fig.1
).
•
Deactivate the “CLEANING” function
- this function is deactivated automatically after two minutes. If you need to stop the
function sooner, press the “Esc” key.
•
Clean the smoke conveyor compartment (fig.2) -
The boiler is equipped with a removable ash pan “
M
” which collects any
accumulations of soot and ash.
•
When done cleaning, close the cover and ash pan.
If cleaning is not done every 2-3 days, the boiler could go into alarm caused by ash clogging after a few hours of
operation.
Figure 1
Figure 2
