Red Hat CLUSTER FOR ENTERPRISE LINUX 5.0, Configuration Manual, Page: 30 / 114

may vary among computers. However, the objective of this procedure is to
configure the BIOS so that the computer is turned off via the power button
without delay.
4. Exit the
BIOS CMOS Setup Utility
program, saving the BIOS configuration.
5. When the cluster is configured and running, verify that the node turns off immediately when
fenced.
Tip
You can fence the node with the
fence_node
command or Conga.
+-------------------------------------------------|------------------------+
| ACPI Function [Enabled] | Item Help |
| ACPI Suspend Type [S1(POS)] |------------------------|
| x Run VGABIOS if S3 Resume Auto | Menu Level * |
| Suspend Mode [Disabled] | |
| HDD Power Down [Disabled] | |
| Soft-Off by PWR-BTTN [Instant-Off] | |
| CPU THRM-Throttling [50.0%] | |
| Wake-Up by PCI card [Enabled] | |
| Power On by Ring [Enabled] | |
| Wake Up On LAN [Enabled] | |
| x USB KB Wake-Up From S3 Disabled | |
| Resume by Alarm [Disabled] | |
| x Date(of Month) Alarm 0 | |
| x Time(hh:mm:ss) Alarm 0 : 0 : 0 | |
| POWER ON Function [BUTTON ONLY] | |
| x KB Power ON Password Enter | |
| x Hot Key Power ON Ctrl-F1 | |
| | |
| | |
+-------------------------------------------------|------------------------+
This example shows ACPI Function set to Enabled, and Soft-Off by PWR-BTTN set to
Instant-Off.
Example 2.10.
BIOS CMOS Setup Utility
: Soft-Off by PWR-BTTN set to
Instant-Off
Chapter 2. Before Configuring a Red Hat Cluster
20