CAUTION! Seatool/Recsea STRONGLY recommends the use of Seatool/Recsea genuine
tray and grip assemblies listed below under OPTIONS. Leakage or damages due to the use
of non-genuine options are NOT covered under warranty.
※
The Accessory Shoe on top of the housing can be used for installation of a target light.
Please be mindful of the weight of the light(s) you intend to use. For heavy lights and
strobes please use Seatool/Recsea genuine tray and grip assemblies.
※
Please refrain from using lights attached to the Accessory Shoe as a carrying handle.
CAUTION! Damage is irreparable.
MAINTENANCE
CAUTION!
Allowing saltwater and contaminants to dry on housing can damage functions and
O-rings possibly causing water leakage. Clean with fresh water only, using a soft, dry cloth to
wipe away water.
※
We recommend a complete housing overhaul once every year.
1. After use in salt water, wash off salt and other contaminants by soaking empty housing
thoroughly in a bucket of fresh water (lukewarm) for 10 to 20 minutes.
2. Manipulate all buttons and dials several times to flush out salt deposits and other
contaminants.
3. Wipe any water off housing with a soft dry cloth.
4. Open Back Cover.
5. Using the O-ring Removal Pick, remove O-ring.
6. Clean O-ring groove and contact surfaces using a clean cotton swab. DO NOT clean
housing, Back Cover or Lens Port with volatile organic solvents or chemical cleaning
agents such as thinner, gasoline, and benzine, etc.
7. Perform O-RING GREASING & MAINTENANCE as instructed below before re-installing.
O-RING GREASING & MAINTENANCE ( 1)
※
CAUTION!
DO NOT use silicone grease other than that provided by Seatool/Recsea.
1. Using the O-ring Removal Pick, remove O-ring.
2. Clean sand, salt, other contaminants and old grease from O-ring.
3. Clean O-ring groove and O-ring Contact Surface using a clean cotton swab.
4. Visually and physically check O-ring by running it through finger tips, feeling for cuts,
cracks or any other defects that may cause leakage. Such defects will cause water
leakage, so be sure to replace the O-ring. Be careful not to stretch or pull the O-ring too
much.
5. Squeeze a rice grain sized bead of silicone grease on your thumb and forefinger. Taking
care not to pull or stretch the O-ring too much, uniformly spread grease on O-ring. Too
little grease may cause the O-ring to twist in the groove, possibly causing water leakage.
6. Place O-ring in the appropriate O-ring groove, making sure that it is uniform, not twisted
or bulging out, possibly causing water leakage. When closing back cover, visually check
O-ring surface, tracing a finger over the to making sure no hair, lint or other contaminants
are attached.
IMPORTANT NOTES:
※
When housing is not used for long periods, remove O-ring and place in a plastic bags to
keep it free of dust and other contaminants and store in a place out of direct sunlight.
Please also be careful of prolonged exposure to direct sunlight during use. The O-ring and
housing may become deformed, causing water leakage.
※
After extended periods of non-use, soak closed empty housing in lukewarm for half a day.
Manipulate all buttons and dials several times. Using a soft, dry cloth wipe away water.
5.
Summary of Contents for WHOM-TF3/4
Page 10: ...MEMO ...
