※
Please refrain from using light attached to the Accessory Shoe as a carrying handle.
CAUTION! Damage is irreparable.
MAINTENANCE
CAUTION!
Allowing saltwater and contaminants to dry on housing can damage functions and
O-rings possibly causing water leakage. Clean with fresh water only, using a soft, dry cloth to
wipe away water.
※
A complete housing overhaul is recommend once every year.
1. After use in salt water, wash off salt and other contaminants by soaking empty Housing,
with Lens Port attached, thoroughly in a bucket of fresh water (lukewarm) for 10 to 20
minutes.
2. Manipulate all buttons and dials several times to flush out salt deposits and other
contaminants.
3. Wipe any water off housing with a soft dry cloth.
4. Remove Lens Port and open Back Cover.
5. Using the O-ring Removal Pick, remove O-rings.
6. Clean O-ring grooves and contact surfaces using a clean cotton swab. DO NOT clean
housing or Lens Ports with volatile organic solvents or chemical cleaning agents such as
thinner, gasoline, and benzine, etc.
7. Perform O-RING GREASING & MAINTENANCE as instructed below.
O-RING GREASING & MAINTENANCE ( 1)
※
CAUTION!
DO NOT use silicone grease other than that provided by Seatool/Recsea.
※
Before conducting grease-up of the housing Back Cover and Lens Port O-rings, thoroughly
clean O-ring grooves (Back Cover and Lens Port), and O-ring contact surfaces (Housing).
Be sure to also apply a thin layer of grease to contact surfaces.
CAUTION!
This housing uses three (3) O-rings, one (1) Back Cover O-ring and two (2) Lens
Port O-ring as shown below and on page 5. Please be sure to install the correct O-ring in the
proper place. Failure to do so will result in water leakage.
1. Using the O-ring Removal Pick, remove O-rings.
2. Clean sand, salt, other contaminants and old grease from O-rings.
3. Clean O-ring Grooves and O-ring Contact Surfaces using a clean cotton swab.
4. Visually and physically check O-rings by passing through finger tips, feeling for cuts,
cracks or any other defects. Such defects will cause water leakage, so be sure to
replace the O-ring. Be careful not to stretch or pull the O-rings too much.
7.