15
9. Assembly of the Optional 25600 Fine Filter
Cartridge for CX2500
Fig 9.5
Fig 9.6
Fig 9.7
Fig 9.8
Place an M8 flat washer over the shorter thread (M8 x 16 mm) at the other
end of the paddle assembly as shown in
Fig 9.5
and re-fit the retaining
plate using the four self-tapping screws,
Fig 9.6
.
Place another M8 flat washer over the thread, along with the M8 self-
locking nut and tighten the nut. Note that the self-locking nut should not be
fully tightened and should allow the paddle assembly to rotate freely when
operated,
Fig 9.7
.
Place the M10 half nut over the M10 x 45mm threaded section of the paddle
assembly and wind it along the thread until it is just clear of the top of the
filter housing as shown in
Fig 9.8
. (do not overtighten at this stage as the
nut will be adjusted further in the following steps).
Fig 9.4
CX2500 Manual 3.2.indd 15
24/11/2016 12:06
