- 7 -
of the welding wire)
3
Install the welding wire on the shaft beside the wire feeding, and tighten the mounting screws.
4
Press the wire feeding wheel and pressing wheel well, cover the cover of wire feeding bin and the cover
of wire feeding tray
3 Operating Instructions
3.1 Operation Panel Interface
3.2 Welding Operation Instruction
On display
After turning on the power using the switch on the back of the machine, The Amperage display is 000 and the Voltage
display is 000 when in MIG mode. The Voltage display shows no-load voltage in lift TIG and STICK modes. The actual
output current and voltage are displayed only during welding.
Polarity Selection Procedures
There are two basic ways to configure the welder:
Direct Current Electrode Positive (DCEP):The electrode cable (MMA stinger, MIG gun) connected to the positive (+)
1
Voltage display:Display output voltage only when welding,otherwise 000 is displayed
2
Current display:Display output current only when welding,otherwise 000 is displayed
3
MIG welding torch switch:Adjustment is only effective in MIG mode, it has no effect in STICK, and lift TIG
modes.The welding machine can only be operated with the Spool gun torch in the Spool gun torch mode; The
MIG gun only be used for welding in the MIG torch mode.Please check the switch status when using.
4
Mode switch:MIG /STICK /LIFT-TIG functions. In MIG Mode, the button [3] is only effective.it has no effect in
STICK, and lift TIG modes.
5
2T/4T switch.
2T is manual, that is, always press the switch for welding
4T is semi-automatic, that is, pressing the trigger once strikes an arc, when the trigger is released the
machine continues to weld until the trigger is pressed again.
6
Adjust voltage: Adjustment is only effective in MIG mode, it has no effect in STICK, and lift TIG modes.[2] The
voltage display does not change when adjusting the voltage. You can get very good welding results when
pointing the current[7] voltage[6] knob to the same positions.
7
Adjust current: [1] is no change when adjusting the amperage.You can get very good welding results when
pointing the current[7] voltage[6] knob to the same positions.
