- 19 -
5708 07.201
1
TECHNICAL DATA
Power consumption ............................................................................... 2150 W
Voltage ...................................................................................................230 V
~
Maximum planing width in one pass ..................................................... 110 mm
Maximum planing depth in one pass .....................................................3,5 mm
Maximum rebate depth ..........................................................................17 mm
No-load cutter head speed ....................................................................15000 min
-1
Nominal speed of cutter head ............................................................... 10000 min
-1
Supply current frequency ...................................................................... 50 Hz
Protection class (EN 60745) .................................................................
/ II
(Double insulation)
Weight (without guide, adapter, blade holder...) ....................................6,9 kg
SAFETY NOTES
Unplug the plane before making any adjustments or inspections.
Check cable and plug for damage prior to connecting the plane to a power supply.
Replace defective or damaged cable at authorized service centre.
Before turning the plane on make sure that the cutting blades are locked into posi-
tion and do not come in contact with any part of the plane body.
Do not operate the plane if:
– any part of the plane is damaged;
– the ON/OFF switch does not work properly;
– the brushes are sparking at the commutator and a circular flame is visible;
– smoke or a distinctive odour of burning insulation is detected.
Use only cutting blades supplied by or approved by the manufacturer for specific
use with this tool.
Never connect the plane to an electric ground.
Avoid dangerous or explosive environments.
Never allow the plane to become wet.
Turn on the plane before applying it to the work piece.
Always place the cable towards rear of the plane. Do not expose the cable to heat or oil.
Do not carry the plane by the cable.
Do not plane over nails, screws, etc.
Use only sharp blades. Observe continuous feed when planing.
Never place your fingers in the wood shavings discharge outlet. Use a piece of
wood to unblock the shavings ejector.
Switch off immediately if the plane stops (loss of power, jamming of moving
parts,etc.).
Avoid wearing loose fitting clothing that may become caught in moving parts.
Likewise for long hair use a hair net. Eye protection and protective gloves are also
recommended.
Due the noise level it is recommended to wear ear protection!
Never set the plane down while it is switched on. Set the plane down only after the
cutter block stops completely. After finishing the job always remove the plug from the
power supply socket.
When not in use, the plane should be stored in a locked place out of reach of
childern.
For further safety information refer to the additional «Safety Instructions»
enclosed!
