Rebel TOOLS RB-5003, User Manual

Page: 43 / 164

Charging
• The charging indicator lights up during work of the device. If the cutting
speed decreases, or the charging indicator lights up red, please charge
the battery.
• Connect the charger's plug to the charging socket. Plug the charger to
the power outlet.
• During charging, the charging indicator lights up red.
• Once charging is completed, red LED is on. Now the charger can be
disconnected.
Assembling and disassembling the blades
• To place the blade in the device, slide the blade into the blade
socket, while holding the lock blade buttons. After successfully
placing the blade in the blade socket, release the lock blade buttons.
• To take out the blade, press the lock blade buttons.
Note: before switching blades, take out the lock key.
Turning on
• Before first use, make sure, that the battery is fully charged.
• Slide the lock key into the lock key socket.
• To start the device, press the lock-on button and hold the ON switch.
The device will work until releasing the ON switch..
Tips for trimming
• The device can be used for cutting grass, as well as trimming the
hedges.
• The opposite rotating teeth cut on both sides and it is therefore
possible to trim the hedge in both directions.
• A hedge should be wider at the bottom than the top. This will
improve light penetration, keeping the hedge healthy. If possible,
trim both sides of the hedge.
• The best trimming effect is achieved when holding the blade at an
angle of approx. 15°.
43
EN