21
I/O Connections
Alarm Input and Output
Sensor Inputs
The 24-pin I/O connector on the rear panel provides 8 external alarm
inputs .
1.
Connect the I/O cable to the rear panel connector,
2.
Connect the alarm inputs to related sensor switching units, such
as door magnet power, emergency switch, turn signal switch and
brake light, as shown in the figure (right).
For example: the diagram (right) shows that high level is detected
when the brake pad is depressed; otherwise, low level will be
detected. Thus, braking may trigger a device alarm.
Overspeed Alarm
•
If a speed is acquired from GPS, the alarm feature can be enabled
by simply configuring settings via
Setup menu -> Alarm -> Speed
.
•
If speed is acquired from the vehicle, the over-speed alarm feature
can be enabled by connecting it to the speed pulse sensor. The
pulse sensor is connected to SPEED-A and SPEED-B cables of the
device, as shown in the figure (right).
Summary of Contents for RVS-5520
