Realm BY03-VBP-WTR, Instructions Manual, Page: 15 / 17

13
Trouble shooting
Problems Possible Cause Possible Solution
Machine refuses
to start
The machine is not plugged-
in
Plug the machine in
Faulty receptacle Try another receptacle
The fuse has blown Replace the fuse Unplug other appliances
Faulty extension cable Try without the extension cable
Fluctuating
pressure
The pump is drawing in air
Check that hoses and connections are
airtight.
Valves dirty, worn or sticking Contact your service centre
The water supply is not
sufficient
Increase water pressure, check for
blockages and / or change the large pipe.
Pump seals worn Contact your nearest service centre
Machine stops
The fuse has blown Replace the fuse
Incorrect mains voltage
Unplug other appliances
Check that the mains voltage corresponds
to the specifications on the nameplate
Thermal sensor activated Leave the machine to cool for 5 mins
Partially blocked jet
Clean the jet with a needle and by spraying
water rearwardly through the jet
Fuse blows
Fuse too small
Replace it with a fuse with higher amp
consumption than the washer.
Increase in the amperage Try without the extension cable
Machine pulsating
Air in inlet hose / pump
Allow machine to run with open trigger until
regular working pressure resumes.
Inadequate supply of water
generated
Increase water pressure, check for
blockages and / or change the large pipe.
Partially blocked jet
Clean the jet with a needle and by spraying
water rearwardly through the jet
Water filter blocked Clean the filter
Folded pipe Unfold the pipe
Machine turns on
and off by itself
Pump fuse and/or trigger out
of order
Contact your nearest service centre
No water supply Connect the inflow water.
Machine is on but
no water comes
out
Water filter blocked Clean the filter
Blocked jet
Clean the jet with a needle and by spraying
water rearwardly through the jet