-16-
Pearl/Glass Front
TAKE CARE WHEN HANDLING THE
GLASS PANELS!
DO NOT DROP OR TWIST THE GLASS ASSEMBLIES AS THIS CAN CAUSE THE GLASS PANELS TO
IMPACT ON EACH OTHER AND MAKE THEM CHIP OR SHATTER
Refer to Notes on Trims (page14) before starting
•
Before fixing the trim on, make sure that the trim hanging tabs (used on other models) have either
been removed or flattened to give the trim a flat surface to fix to.
•
Remove the two spring loaded trim retainers and the front panel mounting brackets (used on other
models)
refer diagram on page 14.
•
Fit the outer trim to the front of the firebox using 7 screws through the backing panel.
DO NOT
OVER TIGHTEN THE SCREWS
.
•
Once all of the screws are in place around the trim and front panel, fix the stainless steel caps in
place using a very small dot of silicon.
Do not use too much silicon as this can prevent the
caps from sitting flush with the glass.
