-14-
Trim Installation
Notes:
•
The outer trim panel cannot be installed until the wall board has been attached and finished (decorated)
•
It is recommended that the installation of the trims and burner media is left until the room is complete
and all decoration is finished.
•
Leave the protective cardboard cover taped to the front of the firebox using a
low-tack
tape to prevent
plaster dust and debris from entering the firebox and damaging the paint work.
Modern and Classic Grated Fronts
This is the same for both Electronic and Manual versions
•
Remove the front Lower Mounting Screw
•
Fit the Front Trim Assembly so that the lower hook fits over the rear Lower Mounting Screw
•
Fix the Trim Assembly to the Upper Mounting Brackets using an M4 earthing screw (with serrated
washers) at each end.
•
Slide the reflectors into the firebox, between the sides of the firebox and the end of the Trim Grate.
•
Pull the two spring loaded Lower Trim Retainers forward and down until they lock in place as shown
•
Fit the outer trim over the Upper Trim Hooks.
If adjustment of the hooks is required, use a screwdriver
to prise the hooks forward, or push them back until the trim fits flush with the wall.
•
Hold the leg of the trim against the Lower Trim Retainer and slide the Retainer upwards into the slot on
the back of the trim, the spring Retainer will pull back into the cavity once the bracket is horizontal
again.
WARNING: Take care when the spring grabs that the trim is not resting on the hearth as it
could bite into the surface and scratch it. Either hold the trim slightly higher or use a thin piece
of card between the leg end and the hearth.
Proceed to Burner Media Installation (page 18)
