Reaim BY-PW02-B2Z-060-02, Operator'S Manual, Page: 15 / 19

15
top of the area to be rinsed and work your way
down, making sure to overlap your strokes.
IMPORTANT
！
NEVER USE
：
·
Bleach, chlorine products, and other corrosive chemicals
·
Liquids containing solvents (e.g. Paint thinners, gasoline,
oils)
·
Tri-sodium phosphate products
·
Ammonia products
·
Acid-based products
These chemicals will harm the unit and will damage the
cleaning surface.
Shutting Down
Turn the On/Off button on the machine.
Pour the remaining water out from the bucket or turn off the
water source.
Hold the trigger to release water pressure.
If using the base unit directly, disconnect the garden hose
form the water inlet on the base unit.
Disconnect the high-pressure hose connection on the trigger
gun handle.
Release the trigger and lock the gun safety lock.
WARRING
！
Turn off the water supply and squeeze
the trigger to depressurize the unit. Failure to do so could
result in personal injury due to discharge of high -pressure
water.
If you are taking a break of five minutes or more
between cleaning tasks:
Lock the gun safety lock.
Push the On/Off button to stop the machine.
Storage
CAUTION!
Always store your pressure washer
in a location where the temperature will not fall below 32
°
F(0
℃
). The pump in this machine is susceptible to permanent
damage if it freezes. FREEZE DAMAGE IS NOT
COVERED THE WARRANTY.
Store the pressure washer indoors in a dry, covered
area where it is not subject to adverse weather
conditions.
It is important to store this product in a frost-free
area.
Always empty water from all hoses, the pump, the
soap dispense attachment and the bucket before
storing.
CAUTION
！
The use of a pump protector
is recommended to prevent cold weather damage during
storage over the winter months.
WintLong-Tern Storage
If you must store your pressure washer in a location where
the
temperature falls below 32
°
F(0
℃
), you can
minimize the chance of damage to your machine by
utilizing the flowing procedure:

Disconnect all water connections.

Turn on the machine for a few seconds
until the remaining water in the pump
exits, Turn off immediately.

Do not allow the high-pressure hose to
become kinked.

Store the machine and accessories in a
room that does not reach freezing
temperatures.

Do not store near a furnace or other
sources of heat that may dry out the pump
seals.

Operate the pressure washer with
non-corrosive/non-toxic anti-freeze, a
pump saver, or a pump protector before
storing for the winter.
WARNING
！
Before reusing, completely flush the
unit out with clear water. Anti-freeze products can damage
paintwork, so you must ensure there is no-anti-freeze let in
the system before using again!
Maintenance
CAUTION
！
Before working on the pressure washer,
remove the battery form the compartment.
1. To ensure good performance, check and clean the
water inlet filter. Remove the filter and rinse with warm
water to prevent any foreigner matter form clogging the
pump (Figs.22-23)