www.ReadyLIFT.com
-
Phone: (877) 759
-
9991
7
46
-
5780
-
IM
-
AA
Notch the lower control arm strut pocket
as shown. Radius the back edge following
the pocket profile. This is for clearance on
the coil
-
over rod end at full droop.
Coat all raw surfaces with a quality paint
to prevent corrosion.
Install the supplied
coil
-
over top hat adap-
tor using (2) coil
-
over top cap spacers,
1/2 bolt, locking nut and washers.
Torque the
1/2”
hardware to
80 ft
-
lbs
Note: Ensure that the top hat is installed
with the notch facing the reservoir banjo
fitting and the offset towards the frame
(as shown in picture).
The coil
-
over come preset for the
8”
kit.
However, fine tuning may be necessary to
achieve the correct right height.
Adjustments are made by loosening the
preload collar set screw
and turning the
collar to add height (Clockwise) or remove
height (Counter
-
clockwise).
Note: Fine tuning may be required due to
the differences in frame tolerances, added
accessories and/or payload differences.
