4
STEP 4
With the base attached to the divider panels
you can now install the adjustable feet. To
install, line up the holes on the adjustable feet
to the holes on the foot pad and slide the bolts
down through the top so the nut will be on the
bottom of the plate.Tighten nuts.
NOTE: Repeat this entire step for all bases
.
SPECIAL INSTRUCTIONS:
**For longer locker runs that will be using multiple
bases, you will need to separate each base by one
locker compartment. Starting at the first locker at
the far end of the locker run, install your longest
base for that run to the divider panels. Skip a locker
compartment and attach the next longest base you
have for that run. Then skip a locker and attach the
next base. Keep working down the run until you
have all of the bases on.**
**IF YOU HAVE THE REAR SECURITY PANELS
AND YOU ARE USING MULTIPLE BASES ON YOUR
LOCKER RUN, THEN YOU WILL NEED TO INSTALL
THE BACK FRAME LEDGE BARS BETWEEN EACH
BASE. MAKE SURE YOU ATTACH THE REAR AND
FRONT BACK FRAME LEDGE BARS BEFORE YOU
INSTALL YOUR NEXT BASE. THE REAR BACK
FRAME LEDGE BAR HELPS HOLD THE ONE REAR
SECURITY PANEL IN PLACE WHERE THERE IS NO
BASE UNDERNEATH IT.**
STEP 3A.1
Before installing the base of the unit you will
need to install the security panels (SP18, 20 or
24) and the security shelves (SS18, 20 or 24).
There are two different sides to the security
panel. The top has a U shaped channel and the
bottom is an L. Slide the U channel side over the
top of the back frame. Now lay the panel down
so that the L shaped bottom is on top of the rack.
Repeat this process for remaining sections.The
security shelves look very similar to the helmet
boot shelves. The difference between the two
is instead of hooks on the side, the security
shelves have half circle mounts . These half
circles slide over the circular tubing at the top
of the divider panel. Repeat this for all three
sections. When the base is installed it will hold
the security shelves and panels in place.
STEP 3A
