ATHENE 100
– SPREADER RATE CONTROLLER
9
4
Area Display
The area in hectares is derived from the forward speed (or the simulated
speed for the calibration test) and the programmed implement width, and is
accumulated to whichever total is selected on the display – Total 1 or Total 2.
The two separate area totals can be independently reset to zero.
The master cutout when switched off, stops area accumulating. The channel
indicator will flash when area accumulation is overridden and will be on
permanently when area is being recorded.
4.1
Select Area Total
1.
Select the channel.
2.
Press to cycle between the two
area totals.
The display will then show
‘tot.1’
or
‘tot.2’
before displaying the area accumulated
since that total was last reset
4.2
Reset Area Total
1.
Select the channel.
2.
Press to cycle between the two area
totals.
3.
Hold for 5 seconds to zero that total.
Figure 4: Select Area Total
Figure 5: Reset Total 1 / Total 2
HOLD – 5 SEC
