9. Formatting the receiver's memory.
In order to format the memory, press and hold C1 and C2 buttons on the receiver for 15 seconds. C1, C2,
MOM, MONO, BIST diodes will start flashing. The buttons should be released only when the LEDs go out.
Formatting memory:
•
removes all remotes from the receiver,
•
disables the lock of remote adding function,
•
disables the service lock,
•
sets the channel operation mode to monostable with a switching time of 1s.
10. Checking the number of added remotes.
In order to check the number of remotes added to the receiver's memory, after adding or removing the
remote, hold down the button on the receiver for another 5 seconds. The LED will flash to indicate the
number of programmed remotes. The number of tens (from 0 to 20 long pulses) is shown sequentially,
followed by the unity digit (from 0 to 9 short pulses). An example of pulses showing the number of entered
remotes is shown in the drawing.
1
2
PRESS AND HOLD C1 AND C2
FOR 15 SECONDS
RELEASE C1 AND C2 WHEN
C1,C2,MOM,MONO,BIST
GO OFF
number of tens - 4x10
number of unities - 6
Abb.10
Formatting the receiver’s memory.
Fig.11
An example of pulses showing 46 registered remotes.
15s
EN
EN
