- 2 -
INSTALLING THE
#
OMEGA-3v5s
ESC
.
The
#
OMEGA-3v5s
ESC uses any DSM2/DSMX 6 x Channel RX’s including our own “Auto Binding” DSM2-EM(AB)
Rx &
SPEKTRUM
or the
ORANGE
brand from Hobby King. Servo leads are supplied for connecting the ESC to the RX.
Always make sure the servo leads are connected to the correct sockets on the RX.
THESE INSTRUCTIONS REFER TO OUR OWN DSM2 TX HANDPIECES.
CONTROL KNOBS.
The TX-3, TX-5 & TX-7 handpieces all use a small knob for selecting direction change & a large knob for speed control.
USING EXTRA SERVOS.
The
#
OMEGA-3V5s
ESC permits the operation of a regular servo using Ch # 5. Simply plug the servo leads the right
way around into the Ch # 5 servo header so marked in the RX. See the ESC diagram.
SOUND TRIGGER CONTROLS.
The TX-3 has one Ch # 5 pushbutton for triggering a sound system. Plug the Ch # 2 servo lead into the Ch 5 position on
the RX. Activates F2 on the trigger outputs. Or use as a mechanical servo action.
The TX-5 has two knobs for sound triggers although they can be awkward to use. Outputs are F1, F2, F3 & F4. The Ch
5 pushbutton is also available. See TX-3 above.
The TX-7 has four pushbuttons on the handpiece that are intended to trigger 4 x sound effects or control accessories.
They operate F1, F2, F3 & F4 on this ESC. The Ch 5 pushbutton is also available. See TX-3 above.
A pushbutton on the ESC pcb is used for initial speed calibration and making system program changes such as Start/Max
voltage, default direction start, system reset & sound trigger outputs from momentary to latch ON – OFF. If you need to
calibrate the system you must download the full instruction manual from the RCS website. See URL on page # 1.
LOCOMOTIVE SEPARATION.
2.4 GHz R/C systems are not separated with crystals. Every TX has a unique identifier code. They are all legal for air &
ground use. Most SPEKTRUM RX’s (and DSM2 clones) can be “BOUND” to the TX 20 handpieces.
“BINDING” must be done before the system can be used. See page # 4.
You can mount the
#
OMEGA-3v5s
PCB with double stick tape or non conductive silicone. Do not allow metal objects
to touch the rear of the PCB. Damage to the PCB may result.
The # ESC-LEADS kit.
These connect any 2.4 GHz RX to the
# OMEGA-3v5 ESC.
Insert the # ESC-LEADS as follows.
1 = Throttle. 2 = Aileron.
3 = Elevator. 4 = Rudder.
Insert the 1 x 3 way servo cable into the
DSM2 RX #1
T
hrottle servo output.
Single leads go into
A (2)
,
E (3)
&
R (4)
.
PLACING RX ANTENNA.
It does not matter where you place the RX and antenna(s). We have at least 150’ + range with the system in plastic
locos. There is NO “glitching” or “Rusty Bolt Effect”. 2.4 GHz RX’s have been successfully used for some years with the
RX & antenna inside a dummy water tank of a live steam loco and inside expensive brass electric locos.
Turn the 2.4 GHz TX OFF to save the batteries & the loco will “Cruise” along until the TX is turned ON again & manual
control resumed.
