41
VACUUM FAN
(FIG.8)
The vacuum fan 1 sucks up the dust raised by the brushes.
!
Warning!
Shut off the vacuum system by pressing the switch 8 fi g.1 to position “A” when working on wet fl oors.
When driving the motor-sweeper from one place to another without, proceed as follows:
- stop the turning of the brushes (see “
controls
”, f g.1 - point 6).
- lift the brushes (see “
controls
” - f g.1 - point 10 - 13)
- Shut off the vacuum system (see “
controls
” - f g.1 - point 8).
DUST FILTERS
(FIG.9)
The f lters 1 remove the dust from the air sucked through the sweeper. The f lters must be kept permanently eff cient.
!
Warning!
If dust starts blowing out form the sweeper, the fi lters are dirty and must be cleaned.
Cleaning the fi lters
Whenever motor sweeper raises dust during sweeping, the f lters must be cleaned. The cleaning procedure is as follows:
- press the switch 8 f g. 1 in position “C” to use the automatic shaker 2 for about 10 seconds.
!
Warning!
Do not move the lever for a long time as this may cause damage to the electrical system.
- about once a month, to keep the machine cleaner and ensure better service, remove the f lters and clean
them thoroughly with an air jet or preferably with a vacuum cleaner , starting from the inside where more
dust accumulates. When replacing the f lters, take care that the rubber seal 3 is in place in the lower part.
DUST FLAPS
(FIG.10)
The dust f aps prevent the dust raised by the brushes from blowing out from under the sweeper . They must
therefore be kept in peak condition and replaced if they become worn or damaged.
Replacing the fl aps
- Remove the f xing bolts and remove the worn or damaged f ap.
- Fit a new f aps 1-2-3-4 and secure it in position with the same bolts. The side and rear f aps should ride at
about 3 - 4 mm above f oor level.
REFUSE CONTAINER
(FIG.11)
The refuse container collects the refuse picked up by the brushes.
When the refuse must be unloaded operate as follows:
- unlock the closing hook 2 .
- slide the refuse container 1 from its housing.
- unload the container.
To f t the refuse container, keep its front part raised and push with a foot until completely goes into its housing.
The rear edge A of the bin must f t into the two upper slides B.
Engage the closing hook 2.
ENGLISH
Summary of Contents for SLALOM
