READ INSTRUCTIONS CAREFULLY BEFORE USING
THIS PRODUCT. SAVE INSTRUCTIONS FOR
LATER REFERENCE.
PRODUCT IS NOT SUITABLE FOR PHASE DIMMING
Products must be installed by a suitably qualified
professional only. Installations must conform to national
installation codes and accident prevention regulations.
If using a track adaptor, ensure it is compatible with the
track system installed. Failure to do so may result in
danger of electric shock and damage to the product.
Ensure electrical rating shown on product label
conforms to mains voltage supply.
Do not modify the product in any way. RCL accepts
no responsibility for damage caused by modifying
this product.
Product is rated IP20 unless otherwise stated. Install
indoors only and away from damp or wet environments.
This symbol indicates the minimum distance to a
lighted object and must be observed.
Caution, product will become hot in use. Allow to cool
before touching.
Dispose of this product in accordance with WEEE or
other national regulations.
Products marked with this symbol are compliant with
Class 2 regulations.
If you have any difficulty installing this product
please contact:
Remote Controlled Lighting Ltd (UK)
42 Riverside Road, London SW17 0BA
+44 (0) 20 8404 2400
Remote Controlled Lighting Ltd (Asia)
Unit 13, 8/F, Lai Sun Yuen Long Centre
21-35 Wang Yip Street East,
Yuen Long, Hong Kong
+852 2310 9733
Installation Instructions
Remote Controlled Spotlight Type DR8 Mk2
Important Safety Information
DOC-260-A
Copyright © 2016 Remote Controlled Lighting Ltd. All Rights Reserved.
BEFORE YOU START
Read these instructions carefully. For the latest
instructions on all our products see
www.rclighting.com/downloads
These instructions cover the following
installation methods:
3-Circuit Installation
2-Circuit Installation
1-Circuit Installation
Monopoint Installation
Trough Installation
Lamp Change - QR111
Lamp Change - HIR111-CE-P
Lamp Change - HIT-CE
Accessory Change
Snoot Installation
A
B
C
D
E
F
G
H
I
J
1
2
3
4
5
6
Ensure that the track system where the DR8 luminaire
is to be installed is compatible with the Eutrac
3-Circuit adaptor.
A
3-Circuit Track Installation
If the spotlight is to be controlled via DMX or DALI,
ensure that track system includes Data Bus. See For
more information on DMX Installation see DOC-083.
NOTES
2
3
1
N
*note orientation
Insert the track adaptor into track system. Take care
to avoid any fixing screws holding the track onto the
ceiling.
To mount the track adaptor into the track system, first
check that both the selector knob and the adaptor
lock are disengaged, as shown below.
Rotate selector knob to the desired circuit position
(see section 7).
Rotate adaptor lock clockwise 90° to connect the
adaptor to the neutral circuit.
When installing the adaptor into the track, ensure that
it is orientated correctly. Align the tabs with the
slot on the track.
PAGE 1
