RCF UP 9501, User Manual

Page: 25 / 40

25
ENGLISH
FUNCTION DESCRIPTION
1 LED TEST
Check of all LEDs, which light up for a few seconds (a text
message will be displayed).
2 SYSTEM RESET Reset / re-initialization of the device.
3 SYSTEM OFF Device shut-down command.
FUNCTION DESCRIPTION
1 BOARD Hardware notes.
2 AMPL
Information about the proper operation of internal amplifiers.
3 ACCESSORY
Information about the A , B ports for accessories (i.e. TS 9918
remote controls).
4 ABOUT
Firmware notes.
SYSTEM MENU
INFO MENU
ROUTING MENU
Calibration of each audio output (necessary for detecting line faults).
Select one of the audio output OUT 1/2/3/4 (that correspond to its respective internal
amplifier) to carry out its calibration.
Menu concerning the audio matrix, where to match sources and destinations.
After selecting an audio output (
OUT 1, OUT 2, OUT 3, OUT 4
), use the
CONTROL
SELECTION 4
encoder to choose an audio channel (to be sent to the selected output)
among:
BGM 3
,
AUX IN, BUS 1
,
BUS 2
,
BUS 3
,
BUS 4
or
ZERO
(no selection).
Choose
MONITOR
to select (by using the
CONTROL SELECTION 4
encoder) the
audio channel sent to the internal loudspeaker 28
a
(MONITOR).
The choice is made among: OUT 1/2/3/4 (audio outputs), INT.SINE (internal sine wave),
BUS 1/2/3/4 (internal buses), BGM3 or AUX IN (audio inputs), ZERO (no selection).
LED test, system reset and shutting down.
Information about the device.
CALIBRAT MENU