RCF MZ 8060, User Manual, Page: 49 / 52

49
ENGLISH
Parameter2 Value = 255 .
(dB Level +90)
100
Parameter2 Value = 255 .
dB Level - Min Level
Max Level - Min Level
EXAMPLE 1:
GET_LEVEL M_IN 3<CR>
Returns master input 3 fader level as set on the master unit.
The device will respond to the above command with a string similar to the following:
ACK GET_LEVEL M_IN 3 239<CR>
EXAMPLE 2: GET_LEVEL M_IN 9<CR>
Returns slave input 1 fader level as set on the master unit.
EXAMPLE 3: GET_LEVEL S_MTX 3 6<CR>
Returns master input 3 to slave output 6 matrix node level.
SET_LEVEL
Updates current level of either an input / output channel or a control group or an audio
matrix node fader.
Generic command syntax is the following:
SET_LEVEL <CONTROLLER TYPE> <PARAMETER 1> <PARAMETER 2>
<PARAMETER 3><CR>
<CONTROLLER TYPE> can be one of the following values:
M_IN to update a master device input fader level
S_IN
to update a slave device input fader level
M_OUT to update a master device output fader level
S_OUT to update a slave device output fader level
M_CGRP
to update a master device control group fader level
S_CGRP to update a slave device control group fader level
M_MTX
to update a master device audio matrix node level
S_MTX to update a slave device audio matrix node level
<PARAMETER 1> is the channel number for all controllers types except for M_MTX and
S_MTX .
It must be in the range: 1 to16 for master/slave input fader levels, 1 to 6 for master/slave
output fader levels, 1 to 16 for master/slave control group fader levels.
Input channels 1 to 8 belong to the master unit, input channels 9 to 16 belong to the slave
unit.
<PARAMETER 2>
is the target level of the addressed fader controller for all controller types
except for
M_MTX
and
S_MTX
. It must be in range 0 to 255.
While most faders have a range of –90 dB to +10 dB, the following formula can be used to
calculate the
<PARAMETER 2> value corresponding to a given target fader level in dB:
Notice that if a fader has a different range than –90 dB to +10 dB, the formula that can
be used to convert from target fader level in dB to the corresponding
<PARAMETER 2>
value will be the following:
where
Min Level and Max Level are the fader lower and upper bounds in dB, respectively.