RCF MZ 8060, User Manual, Page: 11 / 52

11
ENGLISH
HOW TO LINK TWO MZ 8060 EACH OTHER
EXTENSION LINK
EXTENSION LINK
FROM / TO MZ 8060
FROM / TO MZ 8060
OUT
OUT
MZ 8060 (1)
MZ 8060 (2)
IN
IN
GND
Ground
P
Non-inverting pin (RS 485 A)
N
Inverting pin (RS 485 B)
V
24 V dc
22
Input for the power cord (to be connected to mains through an earthed socket only).
The
RDNET
software is protected by international copyright laws and is to be used to
configure the
RCF RDNET
system only.
It is not allowed to modify or change or try to decompile this software.
In no event shall RCF S.p.A. be liable to end-users for any damage whatsoever, including
but not limited to financial damages for loss of business profits or business information
due to the software use or inability to use this product.
The foregoing provision is effective even if RCF S.p.A. has been advised of the possibility
of such damages.
Even if the SOFTWARE has any material, verifiable and reproducible program errors, RCF
S.p.A. shall have no obligation to modify such errors.
NOTES ABOUT THE RDNET SOFTWARE
Two MZ 8060 can be linked each other to get a 16-input 12-output matrix
through the EXTENSION LINK ports (RJ 45 sockets) on their rear panels.
Connect the
EXTENSION LINK OUT
15
output of the first MZ 8060 to the
EXTENSION LINK IN 14 input of the second MZ 8060 and vice-versa.
T
he Two cables musT be unshielded
caT 6
and noT longer Than
20
cm
(
abouT
8
inches
).
w
hen using The
Pc
sofTware
(
read The resPecTive manual secTion
‘s
ofTware
configuraTion
> u
niT
s
eTTings
’),
seT The firsT
mZ 8060
To
masTer
and The
second
mZ 8060
To
slave.
21
REM-CTRL
REM-CTRL RS 485 serial port for remote control via third-party software
(removable connector).