RCF MZ 8060, User Manual, Page: 32 / 52

32
ENGLISH
MATRIX NODES
For each bus, there is:
-
A rotary control (–90 to +10 dB) for any general settings of the signal level in the
respective BUS (the default setting is 0 dB: no adjustment).
-
A button (in the picture above
A BUS
) for the choice of the bus to which ROW LEVEL
sliders (matrix node levels, see below) are assigned, sliders that change their colour
according to the selected BUS.
Every audio input has the following controls:
ON : toggles the audio input in the correspondent bus. It is the main switch of the node.
A-MIX1 : assigns the node to the control of the automixer no.1, which automatically
adjusts the audio input level according to the number of open channels.
A-MIX2 : assigns the node to the control of the automixer no.2 (alternative to the
automixer no.1).
IMPORTANT: automixers need to be set in the AUTOMIX SETUP window, see
the ‘Automixer’ manual section.
ROW LEVELS: each matrix node has a slider to adjust its level
(from –40 a +20 dB, default setting is 0 dB: no adjustment).
The BUS selection is made by clicking one of the buttons from
A BUS to F BUS . Sliders change their colour according to the
selected BUS.
With the MASTER unit only, slider total number is 48 (8 inputs
x 6 BUS / outputs). If the SLAVE unit is linked, there will be 192
sliders (16 inputs x 6 BUS / outputs x 2 matrices).
MATRIX NODES