RCF AM 1064, Owner'S Manual

Page: 9 / 24

9
ENGLISH
MIC.
LINE
Audio input sensitivity set to MIC. Use: dynamic microphones.
Audio input sensitivity set to LINE. Use: ‘line’ level signal.
MIC.
LINE
Audio input sensitivity set to MIC. Use: dynamic microphones.
Audio input sensitivity set to LINE. Use: ‘line’ level signal.
e
Audio input 1 (XLR connector):
Balanced connection + hot
– cold
GND ground
Unbalanced connection
d
o
noT
use an unBalanced connecTion when The
‘p
hanTom
’
power supply is swiTched on
!
T
he Balanced connecTion is always preferaBle
,
especially wiTh caBles longer Than
5
meTers
.
r
MIC./LINE Audio input 2 MIC/LINE switch.
t
Audio input 2 (XLR connector, see ‘Audio input 1’
e
for the connection).
y
(AM 1125 only) Audio input 3
(XLR connector, see ‘Audio input 1’
e
for the connection).
u
(AM 1125 only) MIC./LINE Audio input 3 MIC/LINE switch.
i
Audio input 4 (AM 1125) / 3 (AM 1064) for dynamic microphones
(XLR connector, see ‘Audio input 1’
e
for the connection).
o
Audio input 4 (AM 1125) / 3 (AM 1064) with dual RCA connector for ‘line’ level
signals (i.e. CD / MP3 players, tuners, etc.).
T
he Two channels of The sTereo source connecTed To The audio inpuT
4 (am 1125) / 3 (am 1064)
are summed
(
inside The amplifier
)
To geT a mono signal
.
a
lThough The audio inpuT
4 (am 1125) / 3 (am 1064)
has
2
differenT connecTors
(xlr / rca),
These cannoT Be used To mix differenT signals
;
only one audio source can Be connecTed
.
p
AUX INPUT with dual RCA connector for ‘line’ level signals (i.e. CD / MP3 players,
tuners, etc.).
T
he Two channels of The sTereo source connecTed To The
aux in
are summed
(
inside The amplifier
)
To geT a mono signal
.