EN
Getting Started
Unpacking the system:
You should have the following:
•
one main unit (with 2 main speakers);
• one
remote
control;
• one AM loop antenna;
• one
user’s
guide;
• one safety leaflet.
• Owner
registration
Card
Back View
1. FM Pigtail Antenna
2. AM Loop Antenna Connector
3. Main Speaker Jacks
Using the FM and AM Antennas
Before you use your audio system, you’ll want to make
sure both the FM and AM antennas are positioned prop-
erly. Uncoil the FM antenna at the back of the unit, mak-
ing sure it is fully extended (you may even want to tape it
to the wall behind the unit if possible. The higher the
better.) You’ll also need to connect the AM antenna loop
to the back of the unit if you listen to AM stations.
Rotate the AM loop antenna for better reception.
Connecting the Speakers
Match the red wire (on the left speaker) to red terminal
for the left speaker (L) on the back of the unit and the
black wire (on the left speaker ) to the black terminal for
left speaker (L). Follow the same procedure to connect
the right (R) speaker.
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
4 inches
4 inches
Front View
4 inches
4 inches
2
inches
Side View
MAIN SPEAKERS 6
FM ANTENNA
AM LOOP
RL
+
_
_
+
Release tab to lock wire in
the terminal.
NOTE:
Make sure the insulation is completely removed from the
ends of the speaker wires at all connection points.
Speaker Wire Connection
Push Speaker terminal tab
down to insert wire.
2
1
2
3
RS2635_40-EN 23_12 12/23/03 2:23 PM Page 6
