Getting Started
Using the FM and AM Antennas
Before you use your audio system, you’ll want to
make sure both the FM and AM antennas are
positioned properly. Uncoil the FM antenna at
the back of the unit, making sure it is fully
extended (you may even want to tape it to the
wall behind the unit if possible. The higher the
better.) You’ll also need to connect the AM
antenna loop to the back of the unit if you listen
to AM stations. Rotate the AM loop antenna for
better reception.
Connecting the Speakers
Each speaker has a black (negative) and a red
(positive) jack. When connecting the speakers,
match the red wires to the red jacks and the
black wires to the black jacks.
Connecting the Sirius Connect
TM
Home Tuner
To use Sirius Satellite Radio, you need to connect a
Sirius Connect
TM
Home Tuner (purchased
seperately) to the unit and subscribe to the Sirius
Satellite Radio. To learn more about Sirius Satellite
Radio, see page 16.
After purchasing the tuner, follow the below
steps to connect the tuner.
1. Make sure the unit is in STANDBY mode
(Display shows the clock and backlight is off). If
necessary, press
ON/STANDBY
on the front
panel to turn off the unit.
2. Connect the tuner to the Sirius socket at the
rear panel of the unit.
3.Connect the supplied antenna from the tuner
package. Follows the instruction on the User’s
Manual of the Tuner. Make sure the tuner is
powered by its AC adapter.
4. Press
ON/STANDBY
on the front panel to turn
on the unit.
Installation
To ensure sufficient ventilation, keep the spacings
shown below free from other surfaces:
Release tab to lock wire in
the terminal.
NOTE:
Make sure the insulation is completely removed from the
ends of the speaker wires at all connection points.
Speaker Wire Connection
Push Speaker terminal tab
down to insert wire.
4 inches
4 inches
Front View
4 inches
4 inches
2
inches
Side View
3
EN
RS2058 EN_Sirius 8/5/06 10:55 AM Page 10
