RCA J22H760, User Manual

Page: 42 / 184

42 Chapter 5
Chapter 5: Commercial Interface Menus
Commercial Interface
On Commercial Interface
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
RCU and Local Key
Reset Commercial Interface
MENU Exit ENTER Enter Select
F F G G
G G
G G
G G
G G
G G
G G
G G
G G
- CH Hold : If this function is on then TV will turn off when CH key is held for 4 seconds on an analog pillow
speaker.
- Power Off in Channel List : If this function is on then TV will turn off when CH+ key is pressed on last
channel
Pillow Speaker
Commercial Interface
Off
Off
CH Hold
Power Off in Channel List
MENU Back Select
F F G G
F F G G
Commercial Interface
On Commercial Interface
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
RCU and Local Key
Reset Commercial Interface
MENU Exit ENTER Enter Select
F F G G
G G
G G
G G
G G
G G
G G
G G
G G
Power Management
Commercial Interface
Off
Off
Off
Auto Power On
Auto Power Off
Power Always On
MENU Back Select
F F G G
F F G G
F F G G
Commercial Interface
On Commercial Interface
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
RCU and Local Key
Reset Commercial Interface
MENU Exit ENTER Enter Select
F F G G
G G
G G
G G
G G
G G
G G
G G
G G
- Key Lock : This setting disables the keys on the front of the TV.
- RCU Type : This function assigns RCU type as TV1, TV2. This is used when more than 1 TV is being installed
in the same room.
Note : The remote must be configured to send the matching RCU Type corresponding to this setting.
This is done as follows : On the R130 K1 remote, press hold <SYSTEM> and <1> keys for 5 seconds to set it
to “TV1”. Press and hold <SYSTEM> and <2> keys for 5 seconds to set it to “TV2”.
Key Management
Commercial Interface
On
TV1
Key Lock
IR(RCU) Type
MENU Back Select
F F G G
F F G G
- Auto Power On : This function sets the power state when AC power is applied to the TV.
+ Off : TV will go to stanby mode
+ On : TV will turn on
+ Last : TV will resume the state it was in before AC power was removed.
- Auto Power Off : This function assigns the amount of time an inactive TV will remain on. It can be used by
your facility to save energy.
- Power Always On : TV can not be turned off.