RCA IP900, User Manual

Page: 28 / 32

26 Chapter 4
Illustrations contained in this document are for representation only.
Chapter 4: Additional Information
AUX ON • OFF TV
VIDEO WEB EMAIL VOD
CH +
HOME MUTE
CH -
INFO
KEYBD
OK
EXIT•CLEAR BACK
1 2 3
4 5 6
7 8 9
0
AUDIO•INPUT ANTENNA
REV•REPLAY FWD•SKIP PLAY
RECORD PAUSE STOP
MENU GUIDE
SELECT
TOOLS
VOL
VOL
How to Find Your TV’s Video Input Channel
You must tune your TV to the video input channel if you are using the IP video decoder’s Audio/Video (A/
V) OUT jacks to connect to the TV’s A/V input jacks. You must select the TV’s video input channel before
you can see the decoder’s menus or programming.
The video input channel for TVs varies by brand and model. Below are some steps to try to find your TV’s
video input channel:
Video Input Channel Variations
Button/Switch Button on the Channel
on the TV TV Remote Number
VIDEO VID 1 00
SIGNAL LINE 90
VID 1 VID 91
VID 2 VIDEO 92
S-VID S-VID 93
S-VIDEO INPUT VID 1
S-VIDEO VID 2
SOURCE
AUX
TV button
AUDIO• INPUT
button
• If your TV brand is RCA, GE, or Proscan, press the TV
button on the decoder’s remote control, then press the
AUDIO•INPUT button.
• If you have another brand of TV, see page 14 to see if the
decoder’s remote can be programmed to control your TV.
If so, once completed, follow the step above.
If those options do not work, try the following ideas. You
might access the video input channel by:
• Pressing a button on the TV’s remote control (see the
table below).
• Selecting a specific channel from the TV’s on-screen menu
system (see the table below).
• Tuning directly to the video input channel by selecting a
specific channel number (see the table below)
• Going through all available channels by pressing the
channel up or down buttons on the TV or its remote
control.
If you programmed your remote control to
operate your TV (instructions on page 14),
and you are using audio/video jacks, press
the AUDIO•INPUT button to find the Video
Input Channel.
IP900.04 Additional 10/24/03, 12:35 PM 26