Connections & Setup
28
Chapter 1
4.
Highlight your brand of cable box, and press OK.
If your brand isn’t listed, highlight
Not Listed
and press OK.
Important Note:
Cable box may only be connected to ANTENNA A or
INPUT 1 if it is to be controlled by GUIDE Plus+ system.
5.
Make sure your cable box is on.
Tune the cable box to channel 02 (use the remote control that came with
your cable box, or press the channel buttons on the cable box).
Press OK (the GUIDE Plus+ system starts testing codes).
Important Note:
When code testing is in progress, don’t touch your TV,
VCR, cable box or any of the remote controls for these products.
6.
Look at your cable box. If it is still on and changed to channel 09, the test
was successful. Highlight
Yes,
and press OK (
STEP 3: Configuring for a VCR
appears
).
If your cable box didn’t change to channel 09 or turned itself off, you have
two choices:
No
and
Test this code again.
Test this code again:
If you think the TV, the cable box, or any of the
remote controls might have been touched or bumped during the test,
highlight
Test this code again
and press OK (the GUIDE Plus+ system runs
the same set of codes).
No:
If you don’t think the test was interrupted, highlight
No
and press OK
(GUIDE Plus+ system tests the next code).
Repeat the previous instructions until the TV finds the correct cable box
code. Follow the instructions on the screen.
Note
: If the TV can’t find your cable box code, a troubleshooting checklist
appears. Carefully review each checklist and follow the instructions on the
screen.
Step 3: Configuring for a VCR
1.
If your TV is connected to a VCR, press OK (a screen appears reminding
you to connect your G-LINK cable to your TV and VCR).
If it is not, highlight
No
and press OK. Go to Step 4: Confirming Your
Settings on page 29.
1614682A.03_cx_8.22
9/18/03, 5:28 PM
28
