RCA F38310 - 38" 16:9 HDTV, User Manual

Page: 25 / 100

Using the Remote
2 1
Using Direct Entry
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component on the
code list in the section “Remote Control Codes” on the following
page.
3. Press and hold the remote control button you want to program.
4. Enter the code from the code list.
5. Release the button, and then press ON•OFF to see if the component
responds to the remote control commands. If it doesn’t, try pressing
the component button and then ON•OFF again.
6. If you get no response, repeat these steps using the next code listed
for your brand until the component responds to the remote control
commands.
Using the Remote to Control a
Component
Once the remote has been programmed successfully, you are ready to
use it to control your components, such as a VCR, DVD player, or
laserdisc player.
To operate the component:
1. Press the component button (VCR1, VCR2, DVD, or AUX) to set the
remote to control the component.
2. Press ON•OFF to turn the component on or off.
3. Use the remote control buttons that apply to that component.
This remote control may not operate all
models of the brands that are shown. Use
the codes shown in this manual, or on the
sheet packed with your remote control.
Use the AUX button to control a separate
satellite receiver, if necessary. Do not
reprogram the DIRECTV button.