RCA F38310 - 38" 16:9 HDTV, User Manual

Page: 24 / 100

2 0
Using the Remote
Programming the Remote Control
The universal remote can be programmed to control most brands of
remote controllable components, such as VCRs. The remote is already
programmed to control most RCA, GE and PROSCAN TVs, VCRs, DVD
players, and laserdisc players.
Testing the Remote Control
To determine whether the universal remote control requires
programming, turn on a component, such as a VCR, point the remote
control at the VCR, and press the VCR1 button. Then press ON•OFF or
CH + (channel up) or CH - (channel down) to see if the VCR responds to
the remote control commands. If not, the remote control requires
programming.
Programming the Remote Control
Using Automatic Code Search
The following instructions can be used to program the remote control. If
you want to exit the automatic code search without programming any
of your components, press and hold CLEAR until the LED light on the
remote control turns off.
1. Turn on the component you want to control (VCR, etc.).
2. Press and hold the button you want to program (VCR1, VCR2, etc.).
Note that the AUX button can only be programmed using direct
entry (see the next section for details). While holding the
component button, press and hold ON•OFF until the LED light on
the remote control turns on, then release both buttons.
3. Point the remote control at the component you want it to control.
4. Press and release PLAY, then wait five seconds or until the LED light
stops flashing.
At this point the remote control is searching for the correct code to
program. If, after five seconds, the component you want to control
does not turn off, press PLAY again to tell the remote control to
search the next set of codes.
Continue pressing PLAY until the component turns off or you have
searched through all of the codes. There are 20 total sets of codes. If
the component does not turn off after pressing PLAY 20 times, then
the remote cannot control that particular component.
If the component you want to control does turn off:
1. Press and release REVERSE, then wait two seconds. Repeat this step
until the component turns back on.
2. To finish, press and hold STOP until the LED light on the remote
control turns off.
You’ll use these buttons when
you program the remote to
control any component.
The remote may not operate all
models of all brands.
STOP
TV ON OFF
AUX DVD
PLAY REVERSE
CH
+
CH -
V
O
L
V
O
L
VCR1
VCR2
DIRECTV
LED