Connections and Setup
3
Graphics are for representation only.Your unit may differ slightly.
Install the battery beneath the player using the locating pegs and retaining brackets intended for
this purpose:
1.
Lay the battery down flat as shown in the illustration.
2.
Place the player on top of the battery so that the battery’s locating pegs fit into the fixing
holes ( ) on the underside of the player.
3.
Slide the player backwards on the battery until it clicks into place.
Note: Contact the applicable local governmental office and your current waste removal provider for assistance in
determining the appropriate disposal method in your area.
Inserting the battery beneath the player
The battery has 3 locating pegs and 2 retaining brackets.These must be inserted into the player’s 3
holes and 2 slots respectively.
Fit the CR 2025 battery into the remote control unit as indicated.
In order to avoid any risk of explosion, observe polarities indicated inside the battery compartment. Replace only
with the type of batteries specified above. Do not throw them into fire, do not recharge them. If you are not using
the remote control unit for an extended period (several weeks), take the battery out.
Initial setup of your remote control
Locating pegs
Retaining brackets
1
2
3
DRC622_new 9/12/03 2:30 PM Page 3
