RCA BR200D-U1, Service Manual

Page: 77 / 77

BR200D-U1/BR300D-U1
Service Manual
70
Appendix 3: Troubleshooting
No. Problems Solutions
1
The radio cannot
be switched on or
no display after
switched on. z Battery pack may not be installed properly. Remove the
battery pack and install it again.
z Battery power may be insufficient. Recharge or replace
the battery pack.
2
The battery power
consume quickly
after charging.
z The battery life is finished; please replace it with a new
battery pack.
3
Cannot talk to or
hear
other
members in your
group.
z The frequency or CTCSS/DCS signaling are not
identical and please reprogram it.
z Make sure the setting of the selective signaling 5-Tone
in he RX Squelch Mode is proper.
z
Beyond the radio efficient communication range.
4
Other voices from
non-group
members are
heard on the
channel.
z Change the CTCSS/DCS tone, and make sure change
the tone on all radios in your group.
z Please set 5-Tone selective signaling on the channel.
5
Communication
range is too small.
z Make sure the antenna is well connected.
z Make sure the antenna is the originally supplied one.
z Check if the battery power is in the normal state.
z
Ask your local dealer to adjust the squelch level.
6
Unable to
transmit.
z Make sure the PTT button has been pressed
completely.
z Battery power may be insufficient. Recharge or replace
the battery pack.
z Transmitting frequency has not been set on the channel
and the radio has been remote killed.
7 Noise is too loud.
z Battery power may be insufficient. Recharge or replace
the battery pack.
z Beyond the efficient communication range.