TURN OFF ALL POWER AT
CIRCUIT BREAKER/FUSE PANEL.
Read entire Installation Manual
before proceeding.
All wiring should comply with
local electrical codes and requires
a qualified electrician.
The total lighting load connected
to Stealth must not exceed 8 amps
(1000 watts incandescent or quartz,
500 watts fluorescent). To switch
more wattage an electrician can
install a relay.
Line Carrier Remote Control
Systems such as X-10, Leviton or
Radio Shack are incompatible with
sensors and cause false activations.
Do not install sensors on a
circuit that feeds motor loads
like kitchen appliances, HVAC
equipment, washer/dryer, or garage
door openers.
Sensor must be below and as far
as possible away from lights.
Sensor functions best when the
direction of expected movement is
across its detection pattern, not
towards the sensor.
Mount 6–12 feet high for
optimum range and detection.
STL200 floodlight kits come pre-
wired and assembled on the RC
CU4 EZ plate, allowing for mounting
on round, rectangular or octagonal
surface or recessed boxes.
Cautions:
Mounting Plate:
1
Bar
Hook
Screws
CU4 EZ
Plate
Universal
Mounting Bar
Gasket
Center
Screw
Insert
close-up
plugs in
unused
holes
Finishing
Cap
O-Ring Gasket
Mounting
