Rev: 2014.11.04.v001a
23
Test fit the upper fuselage section to
the airframe, depending on the servos
used, there may be some trimming
needed for a good fit
Look everything over closely and make
sure the fit up is nice and flush at all
the mating surfaces
Remove the upper fueslage and lay
down a medium bead of Welders to
entire length of the mating area
Bring the pieces together right away.
Fully engage the tabs, make sure there
is good fit up everwhere and that
everytthing is square
Check and re-check from every angle
for squareness
Set this aside and let dry for a couple
hours
