L39“Albatros“ 90mm edf
Pagina 32
Make some air intake openings on top of the fuselage
The outlet is the opening at the fuselage where the wing is mounted
EDF mounting
Use the wemotec midi fan evo or schuberle fan (that fans do work do not use a fms fan or something
this will not work in a rbc kit edf jet), slide the between duct in the outlet duct fasten with tape , fit fan
and fasten with 2,9x13 fasteners
Place speed controller and receiver also there, place battery’s in front of fuselage , fastened with
Velcro and foam for good control of your CG We had a separate receiver battery (Nihm 4cell 1500) in
the front the cg was no problem that way
Finish:
Fill all dents with lightweight filler and sand
Finish wing and stabilizers with 25gr glass fuselage with 50gr glass and use Pu or epoxy or eze kote,
Now finish with... Vallejo, humbrol or we used cheap spray cans... take care for the vacuumformings as
some paints will not hold as good, or worse will dissolve or make it brittle, use a primer for this
