Service and Maintenance
e
LEG
www.Razorinternational.com
Page 8 of 8
e
LEG Service
The
e
LEG
power drive gearbox is designed to be maintenance free. There is
no serviceable parts. The gearbox is a sealed pre-lubricated unit, as is the
battery, the charger and controller.
Should any of the components have an issue, the drive system has been
designed to be modular so that each component can be readily replaced in
minutes. These components are the battery and its associated charger, the
electric motor and the electronic controller. Please refer to the illustration
below for change out of each component.
To remove electric motor first
remove the two M8 bolts and the
motor can then be pulled out
from the gear box(Note: The
longer M8 screw is bolted to the
left hole of the controller).
Electric
Motor
Motor retaining bolts &
spring washers
(6mm Hex Key
required,Max Torque
20N.m/14.75ft.lb)
Note: Long M8 bolt must
go in the left side
To remove the controller,
first disconnect the
harness and remove the
motor then remove the two
M4 screws and the
controller can be lifted out.
Controller
Controller
retaining screws
(T20 Torx key
required, Max
Torque 2N,m/
/1.47ft.lb
CAUTION: DO NOT ATTEMPT TO REMOVE BEFORE
FIRST DISCONNECTING BATTERY POWER
Drive Shaft protective cover.
Remove to operated gearbox
manually with standard crank
handle
Refer page 2 for
detailed parts
breakdown
