10
Raz-AP/SP Dealer Manual
20170110
2.5 Adjustable Footrest Installation
1. Remove wrapped footrests from the inner accessory box.
2. Place the footrest hanger tubes into the receivers, welded at
the front of the chair frame
. If the support tubes are directed
forward, the pins on the tubes will engage with grooves in the
receivers and lock in place.
2.6 Fastener Installation
All fasteners should be installed securely. Locknuts that are
removed for any reason may need to be replaced rather than re-
used. Check performance of nyloc nuts when re-attaching to
screw. There should be significant detectable resistance when
tightening. If not, replace the nyloc nut with a new one. It is
advisable to check annually that all fasteners are secure.
3.0 ADJUSTMENTS
IMPORTANT !
ADJUSTMENTS SHOULD NEVER BE ATTEMPTED WITH THE USER IN THE CHAIR.
3.1 Backrest Adjustment
3.1.1 Backrest Angle Adjustment
Tools required: (1) 3/16
” hex key, (1) 7/16” wrench
1. Loosen and remove the locknuts, washers, and coved spacers
(SP models) on both vertical backrest frame tubes.
2. Remove the middle screws and washers from the
vertical backrest frame tubes.
3. Leaving the inner coved spacers in place (SP models), rotate
the backrest to one of the 3 positions on the backrest
mounting plates.
4. With the backrest in place re-insert the screws through the
selected holes on the backrest mounting plates.
5. Fasten the screws with curved washers and locknuts.
6. Tighten the assembly with a hex key and wrench.
3.1.2 Adjustable-Tension Back Upholstery Adjustment
In order to adjust the back upholstery of the backrest, each strap
can be tightened or loosened to achieve a wide range of positions.
For example, the second and third straps from the bottom can
be tightened to create more pronounced support in the lumbar
area of the back.
