NautoPilot® 5000 Series
102-890.NG001-NG003
Operator Manual
10000001052
86
Edition: 003
2.3.6.2
Speed
Speed sensor not available.
System
In normal operation the system shows the Speed Through Water (STW)
In data failure of STW the system shows (if a second speed sensor is
connected) the Speed Over Ground (SOG).
The speed value of the selected speed sensor cannot be adjusted.
Man Speed
A small icon is displayed, which reminds the operator of acknowledging the
input by pressing the SET button, located on the Autopilot’s front plate.
Value range: 5.0 kn to 90.0 kn (in increments of 0.1 kn).
If manual speed is selected, it is shown in the display (see Figure 50). This value
can be edited without selecting the man Speed option.
For integration in an INS the radio button to select speed is neither visible nor
operable. See also information about heading source selection (see Figure 46).
For messages regarding failure or doubtful data, refer to chapter 2.3.6.1.
Attention:
Only for Track Control mode.
It is important to check the speed value of the connected
ECDIS and the speed value adjusted for the Autopilot
(independent of manual setting or system setting).
They should not be different.
Figure 51: Speed source and speed value (Page function)
