8
Ethernet address
When setting up Ethernet versions of the VTS, you may need to ask your network
administrator for advice about making the Ethernet connection.
Ethernet set-up is not affected by power cycling the VTS.
The Ethernet link uses a 100-base T connection. An RJ45 connector may be wired
to the free end of the cable to facilitate this. The VTS is usually connected to a
network switch (or hub, or router). It is also possible to connect it directly into
the network port on a PC by using a cross-over cable.
8.1
IP address
The VTS needs an IP address to communicate over Ethernet. There are two ways
to get an IP address; either programmed into the unit or using DHCP.
For DHCP mode, the VTS acquires its IP address, subnet mask, and gateway
address from the DHCP server. Otherwise the VTS has a fixed IP address, subnet
mask, and gateway address.
DHCP mode or the IP address can be set or read using the RaytecMaint program
available from www.rayteccctv.com. The RaytecMaint window is shown below:
20
Summary of Contents for PULSESTAR VTS Series
Page 1: ...PULSESTAR VTS Installation Guide Issue 004...
Page 2: ...For your notes...
Page 15: ...11...
