RAYTAC MDBT42Q - AT, Manual

Page: 11 / 68

11
2.3. Default Info
No. Description Default
(1) Device name
Raytac AT-UART
(2) Base UUID
0x9E, 0xCA, 0xDC, 0x24, 0x0E, 0xE5, 0xA9, 0xE0
0x93, 0xF3, 0xA3, 0xB5, 0x00, 0x00, 0x40, 0x6E
(3) Service UUID
0x0001
TX characteristic: 0x0003; RX characteristic: 0x0002
(4) Baud rate 9600bps,n,8,1
(5) Status of flow control Disabled
(6) RF TX power +4dBm
(7) 32.768Khz oscillator Using internal RC with 1000ms calibration time
(8) Logic of BT connecting indicator Output set as logic low when BT is connecting
(9) PHY mode 1Mbps
(10) Logic of wake-up pin Set logic low to wake up in deep sleep
(11) Advertising time Forever advertising with no timeout
(12) Status of DC-to-DC converter Disabled
(13) Connection interval mode Set at min. 20ms and Max. 40ms for iOS/Android usage
(14) Advertising LED pattern 0.5sec on / 0.5sec off
(15) Connecting LED pattern 0.2sec on / 1.8secs off
(16) Serial number Display
“ no data! ” string
(17) ADC value
Value varies from input voltage between
0x0000 ~ 0x03FF (
Hex).
(18) State of response Enabled
(19) Programmable output GPIO
P0.12, P0.13, P0.14, P0.15, P0.16, P0.17, P0.18
and P0.19 are unused