SECTION L: GENERAL SAFETY PRECAUTIONS
To meet commercial water use needs, the temperature Hi-Limt on this hot water boiler is adjustable up to 210°F. However,
water temperatures over 125°F can cause severe burns instantly or death from scalds. The preferred starting point for setting
the control for supplying general purpose hot water is 125°F.
Safety and energy conservation are factors to be considered when setting the water temperature on the thermostat. The
most energy efficient operation will result when the temperature setting is the lowest that satisfies the needs consistent with
the application.
Water temperature over 125°F can cause severe burns
instantly or death from scalds.
Children, disabled and elderly are at highest risk of
being scalded.
See instruction manual before setting temperature at
water heater.
Feel water before bathing or showering.
Temperature limiting valves are available, see note
below.
Maximum water temperatures occur just after the boiler’s burner has shut off. To determine the water temperature being
delivered, turn on a hot water faucet and place a thermometer in the hot water stream and read the thermometer.
The following chart details the relationship of water temperature and time with regard to scald injury and may be used as a
guide in determining the safest water temperature for your applications.
Temperature
Time to Produce Serious Burn
Temperature
Time to Produce Serious Burn
120°F. More than 5 minutes
140°F. Less than 5 seconds
125°F. 1-1/2 to 2 minutes
145°F. Less than 3 seconds
130°F. About 30 seconds
150°F. About 1-1/2 seconds
135°F. About 10 seconds
155°F. About 1 second
Table courtesy of
The Shriners
Burn Institute
TIME/TEMPERATURE RELATIONSHIPS IN SCALDS
The temperature of the water in the hot water boiler can be regulated by setting the temperature dial on front of the
thermostat. To comply with safety regulations the thermostat was set at its lowest setting before the hot water boiler was
shipped from the factory. The illustration below shows the thermostat and how to adjust the water temperature.
To adjust the water temperature, insert a small straight
screwdriver into slotted screw in hole in front of thermostat
and turn wheel to desired setting.
CAUTION!!
- Hotter water Increases the risk of SCALDING!
There is a Hot Water SCALD Potential if the thermostat is set too high.
NOTE: When this hot water boiler is supplying general purpose hot water requirements for use by individuals, a thermo-
statically controlled mixing valve for reducing point of use water temperature is recommended to reduce the risk of scald
injury. Contact a licensed plumber or the local plumbing authority for further information.
53
Adjustment
Screw
Summary of Contents for 302-902
