3. User manual
EN
| 25
Function
yellow
green
Standby:
charging device in stand-by mode, ready to charge
glows
Pre-charge:
tests whether charging is required
blinks slowly
Rapid charge: power pack is charged with constant current
blinks rapidly
Maintain:
charging power is reduced
blinks slowly
Error:
charging cannot start
blinks rapidly
Ready:
the Rayocomp PS 10 is ready for use
glows
Wait:
charging device is not ready yet
blinks slowly
blinks slowly
3. User manual
3.1 General Directions for Operation
3.1.1 Charging the integrated power pack
The Rayocomp PS 10 is equipped with an integrated battery pack to enable the application of the device
without needing to connect it to the mains supply. Please ensure that the PS 10 is switched off before
charging the battery. If for whatever reason the PS 10 is turned on while charging, a warning message will
appear on the display (Er 50) and the device will emit a beep sound.
An empty battery pack requires approx. 4 hours for complete charging. In
order to avoid unnecessary electro-magnetic pollution, please unplug the
charging unit when it is not being used.
And this is how you charge the Rayocomp PS 10:
1. Switch off the device.
2. Connect the charging unit to the mains supply
3. Plug the charging cable into the rear of the device
(see chapter 2.10.2)
4. The charging unit indicates the various charging processes. When the
LED turns green, the charging process is complete and you can use
the device again.
5. Please disconnect both the plug from the rear panel of the device and the charging set from the
electrical outlet.
Note:
The charging status of the power pack is always displayed. This bar indicator allows you to estimate
the length of time left for operation before it becomes necessary to recharge the device. The Rayocomp PS
10 cannot be charged during harmonisation.
