29
Operation
Using the Door Control
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar until the garage door opener
activates (it may take up to 3 presses). Test the door control by pressing the push bar, each press of the push
bar will activate the garage door opener.
Push Bar
LIGHT Button
SERVICE LED
LOCK Button
COMMAND LED
LEARN Button
PUSH BAR
Press the push bar to open or close the door.
LIGHT BUTTON
Press the LIGHT button to turn the garage door opener lights on or off. When the lights are turned on they will
stay on until the LIGHT button is pressed again, or until the garage door opener is activated. Once the garage
door opener is activated the lights will turn off after the specified period of time (the factory setting is 4-1/2
minutes). The LIGHT button will not control the lights when the door is in motion.
The following features are accessible by lifting up the push bar:
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry, or myQ
®
accessories can be programmed to the garage
door opener by pressing the LEARN button on the door control, see page 31.
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote controls while still
allowing activation from the door control and keyless entry. This feature is useful for added peace of mind when
the home is empty (i.e. vacation).
MAINTENANCE ALERT (MAS)
This feature assists the homeowner in ensuring the garage door opener system stays in good working condition.
When the garage door opener needs to be serviced (approximately 4500 garage door opener cycles) the
command (yellow) and service (red) LEDs will begin to alternately flash back and forth. The factory setting for
the MAS feature is off and can be activated at time of installation. Contact your installing dealer for service.
